Table of Contents
Advertisement
Figure 66
1. Clutch stop
6. Remove the idler spring from the post
7. Remove the existing belt from the hydraulic-pump-drive
pulleys and the engine pulley.
8. Install the new belt around the engine pulley and the 2
hydraulic-pump pulleys
Figure 67
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9. Install the clutch stop
10. Install the mower belt; refer to
47).
(Figure
67).
(Figure
67).
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure
66).
Belt Maintenance (page
Controls System
Maintenance
Adjusting the
Control-Handle Position
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
g036860
position.
Adjusting the height:
You can adjust the motion control levers higher or
lower for maximum comfort.
A. Remove the hardware holding the control lever to
the control-arm shaft.
g036859
1. Bolts
2. Slotted hole
B. Move the control lever to the next set of holes.
Secure the lever with the hardware.
C. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
A. Loosen the upper bolt holding the control lever
to the control arm shaft.
B. Loosen the lower bolt just enough to pivot the
control lever fore or aft. Tighten both bolts to
secure the control in the new position.
C. Repeat the adjustment for the opposite control
lever.
49
-
EUTRAL
LOCK
Figure 68
3. Control lever
4. Control-arm shaft
position,
g035858
Advertisement
Table of Contents
