After Operation; After Operation Safety; Using The Fuel-Shutoff Valve; Using The Drive-Wheel-Release Valves - Toro 74447TE Operator's Manual

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units, mufflers,
and engine compartment to help prevent fires. Clean up
oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever you are
transporting or not using the machine.
•
Use full-width ramps for loading the machine into a
trailer or truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.
•
Allow the engine to cool before storing the machine in
any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light, such as on a water
heater or on other appliances.
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located behind the seat.
Close the fuel-shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel-shutoff valve is open when starting the
engine.
1
2
G008948
1. On position
Using the
Drive-Wheel-Release
Valves
WARNING
Hands may become entangled in the rotating drive
components below the engine deck, which could
result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel-release valves.
WARNING
The engine and hydraulic-drive units can become
very hot. Touching a hot engine or hydraulic-drive
units can cause severe burns.
Allow the engine and hydraulic-drive units to cool
completely before accessing the drive-wheel-release
valves.
The drive-wheel-release valves are located on the left and
right sides underneath the engine deck.
1. Disengage the blade-control switch (PTO), turn
the ignition key to off, move the levers to the
28
g036849
Figure 33
2. Off position
g036849
g008948