Verifying The Installation Of An Rp Or Drp Card - Cisco ASR 14000 Series Installation Manual

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Prerequisites
Because chassis operation may be impacted by the removal of an RP card, perform these tasks only if
one of the following conditions exists:
•
•
•
Failure to follow these guidelines can result in interruptions in data communications and network
connectivity.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
Steps
To remove an RP or DRP card, follow these steps:
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the front (PLIM) side or a bare metal surface on the chassis.
Step 2 Identify the card to be removed from the card cage. Remove any cables connected to the front panel of
the card.
Use the screwdriver to turn the two captive screws on the front panel of the card counterclockwise to
Step 3
loosen the card from the slot.
Grasp the two card ejector levers and simultaneously pivot both ejector levers 90 degrees away from the
Step 4
front edge of the card carrier to unseat the card from the backplane connector.
Touching only the metal card carrier, slide the card from the slot and place it directly into an antistatic
Step 5
sack or other ESD-preventive container. If you plan to return the defective card to the factory, repackage
it in the shipping container you received with the replacement card.
What to Do Next
After performing this task, replace any front cover plates.

Verifying the Installation of an RP or DRP Card

This section describes how to verify and troubleshoot the installation of a route processor (RP) or
distributed route processor (DRP) card in the Cisco ASR 14000 series 8-slot line card chassis. For more
detailed information on the RP card, see Cisco ASR 14000 Series Router 8-Slot Line Card Chassis
System Description.
OL-16973-01
When you are certain that the second RP in the chassis is operational and, if not already the active
RP, ready to assume control (this happens automatically)
When the chassis is undergoing scheduled maintenance
When the Cisco ASR 14000 series 8-slot line card chassis is powered down
ESD-preventive wrist strap
Large Phillips screwdriver
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove an RP Card or DRP PLIM
4-43