Installing And Removing Power Components; Information About Installing And Removing The Power Components; Basic Chassis Power Details - Cisco ASR 14000 Series Installation Manual

Installing and Removing Power Components

This chapter provides instructions on how to install and remove the Cisco ASR (Aggregation Services
Router) 14000 series 8-slot line card chassis power components.
This chapter presents the following topics:
•
•
Information About Installing and Removing the Power
Components
This section contains some general information about the power components.
•
•
•
•
•
•

Basic Chassis Power Details

The Cisco ASR 14000 series 8-slot line card chassis can be either DC or AC powered. The chassis power
system (DC or AC) provides the necessary power for chassis components. A chassis with AC input power
requires 8,750 watts to power the chassis. A chassis with DC input power requires 8,000 watts to power
the chassis.
For more detailed information on the two power types, see the
and the
The line card chassis requires that at least the power distribution units (PDUs) and their power modules
be installed to operate properly.
Be sure to install the PDUs before installing the power modules.
Tip
OL-16973-01

Information About Installing and Removing the Power Components

How to Install or Remove the Power Components
Basic Chassis Power Details
Supplemental Unit Bonding and Grounding Guidelines
DC Power Systems
AC Power Systems
Before Powering the Chassis Up or Down
Converting from One Power System to Another
"AC Power Systems" section on page
C H A P T E R
2-8.
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
2
"DC Power Systems" section on page 2-4
2-1