Removing A Slot Cover - Cisco ASR 14000 Series Installation Manual

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Partially tighten the four captive screws on the front panel of the slot cover (either by hand or with the
Step 3
screwdriver) to make sure that they are both engaged.
Step 4 To seat the slot cover firmly in place, fully tighten the captive screws.
What to Do Next
After performing this task, replace any rear (MSC) side cosmetic covers.

Removing a Slot Cover

This section describes how to remove a slot cover from the Cisco ASR 14000 series 8-slot line card
chassis. The chassis is shipped with slot covers over the switch fabric card and RP card slots. Both slot
cover types are removed in the same manner.
reference.) For more detailed information on the slot covers, see the
Carriers and Slot Covers" section on page
Figure 4-13
OL-16973-01
4-6.
Switch Fabric Slot (Half Height) Slot Cover
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove a Slot Cover
(Figure 4-13 shows a switch fabric slot cover for
"Information About Impedance
4-15