Cisco ASR 14000 Series Installation Manual page 121

Chapter 5 Installing and Removing Exterior Components
Required Tools and Equipment
You need the following tool and part to perform this task:
•
•
Steps
To install the exhaust grille, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
Step 1
on the rear side or a bare metal surface on the chassis.
Remove the exhaust grille from its packaging, then set the packaging aside.
Step 2
Align and insert the hooks at the bottom of the exhaust grille into the cutouts at the bottom of the chassis
Step 3
casing on the rear side of the chassis, as shown in
Figure 5-6
Step 4 Rotate the top of the exhaust grille toward the chassis, and snap it into place on the ball studs.
What to Do Next
After performing this task, you may power on the chassis. See the
Down" section on page
OL-16973-01
ESD-preventive wrist strap
Exhaust grille
Inserting the Exhaust Grille Hooks Into the Chassis
2-8.
Installing or Removing the Rear Side Exterior Components
Figure 5-6.
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
"Before Powering the Chassis Up or
5-9