LCD setup
Rockwell Automation Publication 1766-UM001I-EN-P - June 2015
Loading communication EEPROM
Follow these steps to load user programs and data from the memory module to
the controller's memory.
1. Select Load from MM to load user programs and data.
2. If your controller is in a non-executing mode, skip to the next step.
Otherwise switch your controller to a non-executing mode.
3. This screen appears if the load from the memory module is complete. Press
the OK key to go back to executing mode.
For more information on transferring data to and from memory
TIP
modules, see Memory Module Operation on page 159.
In the LCD Setup screen, you can configure the contrast value and backlight for
the LCD.
Using the LCD
Chapter 5
139