System Setting - Skyrc D100 Instruction Manual

It will be operated with the default value of the essential user settings when it is powered
on for the first time.The screen displays the following information in sequence and the
user can change the value of parameter on each screen.
When you are willing to alter the parameter value in the program, press START/ENTER to
make it blink then change the value with INC or DEC. The value will be stored by
pressing START/ENTER once.
ITEM
D C S U P P L Y : O F F
C H 1 : 5 0 C H 2 : 5 0 W
S a f e t y T i m e r
O N 1 2 0 M i n
C a p a c i t y C u t - O f f
O N 5 0 0 0 m A H
T e m p C u t - O f f
O N 5 0 C 1 2 2 F
T e m p e r a t u r e U n i t
C e l s i u s
D100v
2
SELECTION
OFF/
10-100W
OFF/
ON
1-720 Min
( )
OFF/
ON
(
100-50000 mAh)
OFF/
ON
(20 C/68 F -
80 C/176 F
)
Celsius
Fahrenheit

System Setting

DESCRIPTION
In AC mode, it supports Power Distribution.
The total power for Channel A / Channel B
and DC supply is 100W. You could set the
AC Max Power for one output.
When you start a charge process, the
integral safety timer automatically starts
running at the same time. This is
programmed to prevent overcharge the
battery if it proves to be faulty, or if the
termination circuit cannot detect the battery
full. The value for the safety timer should be
generous enough to allow a full charge of
the battery.
This program sets the maximum charge
capacity that will be supplied to the battery
during charge. If the delta peak voltage is
not detected nor the safety timer expired by
any reason, this feature will automatically
stop the process at the selected capacity
value.
The battery's internal chemical reaction will
cause the temperature of the battery to
rise. If the temperature limit is reached, the
process will be terminated.
You can choose the temperature displayed
by Celsius or Fahrenheit as you like.
27 ·