Operating Program - Skyrc D100 Instruction Manual

Ac/dc dual balance charger discharger / power supply

Hide thumbs Also See for D100:

Balance charger (30 pages)

Table Of Contents

Table of Contents

Here is the detailed procedure to make the charger work. All the screens and operations

will take Li-Po BALANCE CHARGE program for example,

Note: We will explain the operating procedure of one channel as

the procedure for channel A and B is identical..

1. Connection

1).

Connecting to power source

There are two kinds of inputs for SKYRC D100 v

A. Operating in AC mode

SKYRC D100 v

AC power cord directly to the main AC socket. (100-240V AC).

Note: The output power in AC mode is 100W totally for Channel A, Channel B and

Power supply.

In AC mode, it supports Power Distribution. The total power for Channel A, Channel

B and power supply is 100W. You could set the Max Power for one output port

(Take Channel A for example)as following,

Then, the channel B and DC power supply will take the rest power automatically (For

example, if you set DC power supply as 20W and Channel A as 50W, the Channel B will

take the rest power of 30W.

If Channel A/Channel B and DC power supply are both working, you can't

NOTE1:

change the power for them.

NOTE2:

If DC power supply is working, you can change the power of Channel A and

Channel B. thus, the DC power supply will take the rest power automatically.

B. Operating in DC mode

Please connect SKYRC D100

Also you could use terminal clips with DC connectors, for attaching directly to 12V car

batteries. It is critically important that you use either a fully charged 13.8V car battery or a

high-quality AC/DC power supply in the range of 11-18V DC output with minimum power

300W or higher to insure reliable performance.

D100v

comes with built-in switching power supply. You can connect the

DC SUPPLY:

CHA:50W

DC SUPPLY:

CHA:50W

with AC/DC power supply by supplied DC input cable.