Omron V700-L11 User Manual page 10

INTRODUCTION
Please observe the following precautions to prevent failure to operate, malfunctions, or undesirable effects on
product performance.
 About installation Site
Do not install this product in the locations subject to the following conditions.
• Place where direct sunshine strikes.
• Place with corroded gas, dust, metallic powder, and salinity.
• Place with condensation due to rapid temperature fluctuations.
• Place with condensation due to high humidity.
• Place where vibration and impact more than being provided by specification are transmitted directly
to main body.
• Place with spray of water, oil, and chemical medicine.
• The working temperature is within the range stipulated in the specifications.
 About depositoty Site
• Store the Controller within the specified ambient storage temperature and humidity.
• Do not store the Controller in a location subject to rapid changes in temperature or condensation.
• Do not store the Controller in a location subject to direct vibration or shock outside the specified
range.
• Do not store the Controller in a location subject to combustible gases, explosive gases, corrosive
gases, dust, dirt, metal powder, or salt.
 About wiring
• Use the power supply voltage specified in this document.
• Ensure correct polarity when connecting to the +/- power supply terminals.
• Do not run high-voltage lines and power lines though the same conduit.
• To avoid static-induced failure, wear a wrist band or equivalent means to release a static charge
before touching a terminal or a signal line within a connector.
• When you put on and take off a CIDRW head, please do not add excessive power to a connector.
• Please connect the correct CIDRW head to the amplifier unit.
 Mounting
• Do not drop the Controller. Doing so may result in injury.
 About cleaning
• Use alcohol to clean this product.
• Do not clean the Controller with paint thinner, benzine, benzene, acetone, or any other organic sol-
vent. These chemicals will dissolve the plastic materials and case coating.
 Maintenance
• Perform inspections both daily and periodically.
CIDRW System
8
User's Manual
Precautions for Correct Use