Table of Contents
Advertisement
FRONT CONTROL PANEL INTERFACE
3–16
2.
Slide the label removal tool under the LED label as shown in the next image. Make sure
the bent tabs are pointing away from the relay. Move the tool inside until the tabs
enter the pocket.
3.
Remove the tool with the LED label.
The following describes how to remove the user-programmable pushbutton label from the
850 front panel.
1.
Slide the label tool under the user-programmable pushbutton label as shown in the
next image. Make sure the bent tab is pointing away from the relay.
2.
Remove the tool and user-programmable pushbutton label as shown in image.
850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES
Advertisement
Table of Contents
