Table of Contents
Advertisement
CHAPTER 1: INTRODUCTION
850 Order Codes
NOTE:
NOTE
850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
USER ROLES
User Access Levels are used to grant varying permissions to specific user roles. User roles
are used by both Basic Security and CyberSentry.
The following user roles are supported:
•
Administrator: The Administrator role has complete read and write access to all
settings and commands. The role does not allow concurrent access. The Administrator
role also has an operand to indicate when it is logged on.
•
Operator: The Operator role is present to facilitate operational actions that may be
programmed and assigned to buttons on the front panel. The Operator has read/write
access to all settings under the command menu/section. The Operator can view
settings from EnerVista or the front panel but does not have the ability to change any
settings. This role is not a concurrent role.
•
Observer: The Observer role has read-only access to all 850 settings. This role allows
concurrent access. The Observer is the default role if no authentication has been done
to the device. This role can download settings files and records from the device.
•
Factory: This is an internal non-user accessible role used for manufacturing
diagnostics. The ability to enable or disable this role is a security setting that the
Administrator controls.
GENERAL RULES FOR USER ROLES WITH CYBERSENTRY
1.
The only concurrent role is Observer. If the user is logged in through serial, front panel,
or over the network, that counts as the role being logged in for concurrency reasons.
2.
Both EnerVista and the front panel provide a one-step logoff. For the front panel, the
root menu has a logoff command. From EnerVista right-clicking on a device and
providing a logoff function from the context menu is sufficient.
3.
The EnerVista Login Screen has "User Name:" and "Password:" fields for the default
remote (Radius) authentication, but when a "Local Authentication" checkbox is
selected the "User Name:" field changes to a drop down menu where the user can
select one of the predefined roles on the 850.
Support of some of the features described in the "Setpoints" section are order code
dependent. The 8 Series unit is ordered with a number of required and optional modules.
Each of these modules can be supplied in a number of configurations specified at the time
of ordering.
The information to specify an 850 relay is provided in the following Order Code figure:
850 ORDER CODES
1–7
Advertisement
Table of Contents
