Level; Expression Pedal/Cv Input; Settings; Changing The Settings - Elektron analog drive User Manual

MID FREQ adjusts the parametric EQ mid frequency.
MID adjusts the amount of boost or cut of the EQ mid frequencies.
HIGH adjusts the amount of boost or cut of the EQ high frequencies.

5.7 LEVEL

LEVEL sets the pedal's final output level.

5.8 EXPRESSION PEDAL/CV INPUT

There are two jacks for connecting an expression pedal or Control Voltage signal source. The Exp
Gain input adds more gain to the value of the preset/panel. The Exp Mid control input goes through
the entire frequency range.

6. SETTINGS

The Analog Drive has a number of settings that can customize the functions of the pedal. These set-
tings are stored globally and are not part of the preset.

6.1 CHANGING THE SETTINGS

1. Press and hold [FOOTSWITCH LEFT] and [FOOTSWITCH RIGHT] for 2 seconds to enter the Set-
up mode. The display briefly shows SU to indicate that you are in Setup Mode. The current setting
is also briefly shown in the display for a second and is also indicated by two or three Circuit LEDs.
The display then changes to show the chosen value of the setting.
2. Turn CIRCUIT SELECTOR to select setting.
3. Turn PRESET to change the value of the setting.
4. Press and hold [FOOTSWITCH BYPASS/SELECT] to save the settings and exit the Setup mode.
Press and hold [FOOTSWITCH LEFT] and [FOOTSWITCH RIGHT] for 2 seconds to exit the Setup
mode without saving any changes.
6.2 SETTINGS
These are the settings and setting values of the Analog Drive.
Setting
Input Channel
14
Display Description
Sets the MIDI channel that Analog Drive uses to receive MIDI data.
No MIDI data is received when set to OF (OFF). (Range 1—16, OF)