Table of Contents
Advertisement
Chapter 8: Spanning Tree Algorithm
Displaying Global Settings for STA
D
G
ISPLAYING
LOBAL
S
STA
ETTINGS FOR
Use the Spanning Tree > STA (Configure Global - Show Information) page
to display a summary of the current bridge STA information that applies to
the entire switch.
CLI R
EFERENCES
"show spanning-tree" on page 1045
•
"show spanning-tree mst configuration" on page 1047
•
P
ARAMETERS
The parameters displayed are described in the preceding section, except
for the following items:
Bridge ID – A unique identifier for this bridge, consisting of the bridge
•
priority, the MST Instance ID 0 for the Common Spanning Tree when
spanning tree type is set to MSTP, and MAC address (where the address
is taken from the switch system).
Designated Root – The priority and MAC address of the device in the
•
Spanning Tree that this switch has accepted as the root device.
Root Port – The number of the port on this switch that is closest to the
•
root. This switch communicates with the root device through this port.
If there is no root port, then this switch has been accepted as the root
device of the Spanning Tree network.
Root Path Cost – The path cost from the root port on this switch to
•
the root device.
Configuration Changes – The number of times the Spanning Tree has
•
been reconfigured.
Last Topology Change – Time since the Spanning Tree was last
•
reconfigured.
W
I
EB
NTERFACE
To display global STA settings:
Click Spanning Tree, STA.
1.
Select Configure Global from the Step list.
2.
Select Show Information from the Action list.
3.
– 199 –
Advertisement
Table of Contents
