Table of Contents
Advertisement
SEC TIONS
Table of Contents
INSTallaTION
Notes about display resolution setting:
• The KVM combiner channel resolution, selected from the channel menu,
determines the size of the channel window. It will not affect the actual
resolution projected by the connected PC.
• Models SC44HU-3 are capable to scale the image allowing the user to fit
more information on the same display size. Scaling is possible almost by
any factor and can be done using the mouse wheel.
• Selection of resolution higher or lower than resolution range of connected
display may result image loss! In this case you can change display to
different type or restore factory defaults.
• To restore factory default settings – use a paper clip or another sharp
object and press momentarily the recessed RfD switch located at the rear
side above the DC power jack.
• See table in page 12 for supported output resolutions per model.
After Installation Checklist
Once completed to set requires settings – check the final device product
configuration with all connected computers operating:
1. Check that each window is connected to the proper PC and have the required
border color.
2. Check that each window is coupled to the proper keyboard and mouse (no
cables are crossed between channels).
3. Check that each window is coupled to the proper fUSB input (if applicable).
4. Check that each window is coupled to the proper audio output (if applicable).
5. Check that all video cable thumb screws are secured.
HSL SC44HU-3 Secure KVM Combiner
1
2
Note: The best possible configuration to the KVM Combiner is when the
output display resolution (as set in system menu) and the channel resolution
(as set in the channel menu) are equal to the computer resolution.
When using two displays it is also recommended that both connected
displays will be identical.
3
4
Channel #1 Input
resolution setting window
5
6
System setup
menu SC44HU-3
24
Advertisement
Table of Contents
