Door Gasket; Glass Cleaning; Door Removal; Glass Replacement - HAMPTON BAY HI300 Owners & Installation Manual

maintenance
|
26

DOOR GASKET

If the door gasket requires replacement, 7/8"
diameter material must be used. A proper high
temperature gasket adhesive is required. A
gasket repair kit, Part # 846-570 is available
from your local Hampton dealer.

GLASS CLEANING

Only clean your glass window when it is cool.
Your local retailer can supply you with special
glass cleaner if plain water and a soft cloth
does not remove all deposits.

DOOR REMOVAL

When handling enamel parts, please handle
with care as they can be damaged.
1) Remove the Top Faceplate by lifting
straight up from the sides.
2) Lift of Mantel Top.
3) Open the Door and lift up of its hinges.
Please be careful when removing the
Door and not to drop onto the Ashlip,
it may chip.
Hinges
DOOR INSTALLATION NOTE
After re-installing the door, carefully
swing open and check the clearance
to the Right Hand Cast Side. If tight or
rubbing, loosen the 7/16 nuts and adjust
the clearance and then re-tighten.
26 |
Hampton HI300 Wood Cast Insert
GLASS
REPLACEMENT
1) Open door.
2) To replace the glass remove the 8 screws
highlighted in the diagram below.
3) Lift of the 4 glass retainers and carefully remove
glass.
4) Place new glass in the door, make sure that
the glass gasketing will properly seal your unit.
5) Position the glass retainer back on. Ensure
that it rests on the gasket and not the glass.
6) Secure glass retainer using the 8 screws. Do not
wrench down on the glass as this may cause
the glass to break.
Remove 8 screws.
Avoid impact on glass doors such
as striking or slamming shut.
Door
HANDLE
REPLACEMENT
1) Remove handle by unscrewing it from the latch.
2) Fit new door handle over latch and screw it in
to place.
Cleaning & Maintaining Your Wood Stove