HAMPTON BAY H300 Owners & Installation Manual

Freestanding woodstove

Hide thumbs Also See for H300:

Brochure & specs (16 pages)

Owners & installation manual (36 pages)

Owners & installation manual (36 pages)

Table Of Contents

Table of Contents

Quick Links

Summary of Contents for HAMPTON BAY H300

Page 1 Owners & Freestanding Woodstove Installation Manual MODEL: H300 Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. 918-214c FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4...
Page 2 ﬁ re ofﬁ cials, or authority having jurisdiction about restrictions and installation inspection requirements in your area. The authority having jurisdiction should be consulted before installation to determine the need to obtain a permit. Hampton H300 Cast Freestanding Woodstove...
Page 3: Table Of Contents
SAFETY LABEL Safety Label for H300 ...4 INSTALLATION Unit Dimensions ...5 Pre-installation Assembly ...6 Residential Installation ...7 Modular Installation Options ...7 Minimum Clearance To Combustible Materials ...8 Minimum Alcove Clearance To Combustible Materials ...9 Additional ClearancesFor Backwall Exit ...9 Floor Protection ...10 How To Determine If Alternate Floor Protection Materials Are Acceptable ...
Page 4: Safety Label
LISTED SPACE HEATER, SOLID FUEL TYPE, ALSO SUITABLE FOR MOBILE HOME INSTALLATION MODEL: HAMPTON CAST FREESTANDING WOOD STOVE - H300 TESTED TO: UL 1482 / ULC S627 INSTALL AND USE ONLY IN ACCORDANCE WITH THE MANUFACTURER'S INSTALLATION AND OPERATING INSTRUCTIONS.
Page 5: Installation
INSTALLATION UNIT DIMENSIONS Top View Front View Side View Hampton H300 Cast Freestanding Woodstove...
Page 6: Pre-Installation Assembly
Screw handle into side door latch. Latch Spacer Handle Hex Head Lock Bolt Washer 3) Place side door handle latch through side door hole. 4) Re-assemble side door plug assembly to secure. Latch Side Door Plug Assembly Hampton H300 Cast Freestanding Woodstove...
Page 7: Residential Installation
OPTIONS: These can be installed at time of installation or added later: Modular Option Adding the blower will increase the area heated by the stove, it can move warm air beyond the room where the stove Blower/Fan is installed (refer to the Optional Blower / Fan Installation section).
Page 8: Minimum Clearance To Combustible Materials
INSTALLATION Please read the section below carefully. Measurements "From Unit" are from the top plate of the stove to a side wall or to a corner, and from the rear heat shield to a back wall. Clearances may only be reduced by means approved by the regulatory authority.
Page 9: Minimum Alcove Clearance To Combustible Materials
Minimum Clearance to Non-Combustibles Unit (with Heat Shield) H300 Min. Mantel Height: 48" 1219 mm Max. Mantel Depth: 12" 305 mm Hampton H300 Cast Freestanding Woodstove From Unit 15" (381 mm) 13" (330 mm) 28" (711 mm) ADDITIONAL CLEARANCES FOR BACKWALL EXIT From Unit 9"...
Page 10: Floor Protection
A combustible ﬂ oor must be protected by non-combustible material (like tile, concrete board, or certiﬁ ed to UL-1618 or as deﬁ ned by local codes) extending beneath the heater and a minimum of 6" from each side and minimum 18" from the front face of the stove and minimum 6" (or the rear clearance to combustibles whichever is smaller) from the rear of the stove.
Page 11: How To Determine If Alternate Floor Protection Materials Are Acceptable
Check the Minimum Recommended Flue Heights (Table Hampton H300 Cast Freestanding Woodstove 1) With your location already established, cut and frame the roof hole. It is recommended that no ceiling support member be cut for chimney and support box installation.
Page 12: Masonry Chimney
There are listed kits available to connect a stove to a masonry ﬁ replace. The kit is an adapter that is installed at the location of the ﬁ replace damper. The existing damper may have to be removed to allow installation. Hampton H300 Cast Freestanding Woodstove...
Page 13: Combustible Wall Chimney Connector Pass-Throughs
Cover opening with and support chimney section on both sides with 24 gage minimum sheet metal supports. See that the supports are fastened securely to wall surfaces on all sides. Make sure fasteners used to secure chimney ﬂ ue liner. Hampton H300 Cast Freestanding Woodstove INSTALLATION...
Page 14: Recommended Heights For Woodstove Flue
17.0 20.0 18.0 22.5 17.5 21.0 18.5 23.0 18.0 21.5 19.0 24.0 18.5 22.5 20.0 25.0 19.0 23.0 20.5 25.5 20.0 24.0 21.0 26.5 20.5 24.5 22.0 27.0 elbow. Hampton H300 Cast Freestanding Woodstove Example b) 21.84' 22.68' 25.20' 27.72'...
Page 15: Mobile Home Installation
Seal the penetration of the outside wall with silicon. Hampton H300 Cast Freestanding Woodstove MOBILE HOME INSTALLATION WARNING: Do not obstruct free air supply to the air inlet duct located at the back of the stove.
Page 16: Listed Components For Mobile Home Installation
INSTALLATION FOR MOBILE HOME INSTALLATION The Hampton H300 Cast Freestanding unit is approved for installation in a Mobile Home if one of the following pipe systems is used. U.S. Installation* METALBESTOS SSII Qty. Part # Description 6DS-VK Connector Kit 6TMH...
Page 17: Brick Installation
Check to see that all ﬁ rebricks are in their correct positions and have not become misaligned during shipping. Hampton H300 Cast Freestanding Woodstove DOOR REMOVAL 1) Push spring lever down while holding onto the door.
Page 18: Optional Blower / Fan Installation
INSTALLATION OPTIONAL BLOWER / FAN INSTALLATION An optional blower is available for the Hampton H300. The blower is factory assembled, wired and ready for attachment to the stove. This unit must be connected to a grounded, standard 120 volts, 60 Hz electrical outlet.
Page 19: Side Shelf Installation
1) Secure two Support Gussets and attach Bracket to the underside of Shelf. Support Gussets 2) Remove Stove Top and place Side Shelf on to Stove Side as shown, aligning Bracket with notch in Stove Side as shown. 3) Secure to Stove Side. Hampton H300 Cast Freestanding Woodstove...
Page 20: Operating Instructions
"AUTO" and the top switch to either "HIGH" or "LOW" for fan speed. This will allow the fan to turn on as the stove has come up to operating temperature. It will also shut the fan system off after the ﬁ re has gone out and the unit cooled to below a useful heat output range.
Page 21: Safety Guidelines And Warnings
5) Do not overﬁ re heater. If the chimney con- nector, ﬂ ue bafﬂ e or the stove top begin to glow, you are overﬁ ring. Stop adding fuel and close the draft control. Overﬁ ring can cause extensive damage to your stove including warpage and premature steel corrosion.
Page 22: Ash Disposal
Other waste should not be placed in the ash container. 5) Before putting the ash drawer back in, ensure that the ash plug is back in place. Hampton H300 Cast Freestanding Woodstove...
Page 23: Creosote
Do not use abrasive clean- ers. 3) Ensure the glass is dry before burning your stove. Hampton H300 Cast Freestanding Woodstove CREOSOTE When wood is burned slowly, it produces tar and other organic vapours, which when combined with moisture, form creosote. The creosote va- pours condense in the relatively cool chimney ﬂ...
Page 24: Handle Replacement
Bracketry at highest position Front of Bracket SIDE DOOR ADJUSTMENT To tighten the side door handle remove, the washer at the end and place next to the front washer. Place beside front Remove washer. end washer. Hampton H300 Cast Freestanding Woodstove...
Page 25: Parts List
Front Vents - Charcoal Grey 220-322 Front Vents - Slate Blue 220-324 Front Vents - Ivory 220-325 Front Vents - Timberline Brown Hampton H300 Cast Freestanding Woodstove H300 MAIN ASSEMBLY Part # 26) 220-110 27) 220-090 28) 220-331 220-332 220-334...
Page 26 PARTS LIST Hampton H300 Cast Freestanding Woodstove...
Page 27: H300 Door Assembly
Door & Grill - Timberline Brown 76) 948-158 Slotted Spring Tension Pin 77) 948-153 Oak Handle 78) 220-089N Latch Door - Nickel Plated 79) 948-155 Hinge Pin - Bottom 80) 948-156 Hinge Pin - Top Hampton H300 Cast Freestanding Woodstove H300 DOOR ASSEMBLY PARTS LIST...
Page 28: H300 Firebrick
91) 802-148 Brick Partial - 4.5" x 4.5" 92) 802-158 Brick Partial - 2" x 8.5" 93) 802-159 Brick Partial - 4.5" x 8.5" (cut angle) 94) 802-160 Brick Partial - 2.25" x 7" H300 FIREBRICK Hampton H300 Cast Freestanding Woodstove...
Page 29 NOTES Hampton H300 Cast Freestanding Woodstove...
Page 30 NOTES Hampton H300 Cast Freestanding Woodstove...
Page 31: Warranty
The Warranty: Limited Lifetime H300: Firebox castings and stainless steel bafﬂ es on all Hampton Wood burning Appliances are covered against manufacturer defects for a period of three (3) years parts and subsidized labour* and a further two (2) years, parts only.
Page 32 Hampton ﬁ replace products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. FPI Fireplace Products International Ltd. is pleased to extend this Limited Lifetime Warranty to the original purchaser of a Hampton Product.

HAMPTON BAY H300 Owners & Installation Manual

Quick Links

Related Manuals for HAMPTON BAY H300

Summary of Contents for HAMPTON BAY H300

Table of Contents