Installing Your Insert; Optional Flue Connector Kit; Flue Connector Bracket - HAMPTON BAY HI300 Owners & Installation Manual

STOP! PLEASE READ CAREFULLY.
CAST COMPONENTS ARE VERY FRAGILE.
USE EXTREME CARE WHEN HANDLING.

INSTALLING YOUR INSERT

Your insert is very heavy and will require two or three people to
move it into position.
1) Remove the Door to make the insert easier to handle. To remove
the Door, open fully and lift it up of its hinges.
Refer to the Door Removal section for an important note on installa-
tion.
Hinges
2) NOTE: For Masonry installation make sure that the irebox is level
with the hearth using non-combustible materials and no more than
1/2 to 1 inch of the leveling bolt.
3) Lift the unit up onto the Hearth and slide into the ireplace opening.
Be sure to leave the unit out at least 3 to 4 inches in order to make
the necessary lue connections and to install the faceplate.
Be sure to protect your hearth extension during the installation,
ie. with a heavy blanket.
DO NOT LIFT OR PUSH THE UNIT FROM THE
ASHLIP, LEFT SIDE CAST or RIGHT SIDE CAST.
THE CASTING WILL CHIP OR BREAK.
Left Side
Cast
DO NOT LIFT UNIT FROM THESE PARTS.
The Straight Flue Adaptor (Part #846-504) shown here, may be
used to produce a secure connection between your lue connector
and the insert collar. Detailed installation instructions are included
with the kit.
Door
Package contains: 3 brackets and 6 screws.
These brackets are to be used to hold the lue liner (not supplied) to
the Insert and keep the connection. The brackets are screwed into
the top of the Insert in the pre-punched holes and then screwed
into the lue liner.
installation
WARNING
Ashlip
OPTIONAL FLUE
CONNECTOR KIT
FLUE CONNECTOR
BRACKET
Hampton HI300 Wood Cast Insert
|
9
Right Side
Cast
| 9