Fan Installation - HAMPTON BAY HI300 Owners & Installation Manual

Installer: Please record unit serial number here before installing blower.
Serial No.______________________________
Your fan should only be installed once the unit is in place in order
to prevent any damage to the fan.
1) Attach the Left and Right Side Fan Facia to the Front Fan
Facia by aligning the Side Facia screw slots with the hole
locations in the Front Fan Facia and secure using 2 screws
per side.
Front Fan
Facia
Backside of Fan Facia Shown.
2) Once the Fan Facia has been assembled carefully slide the
Fan into position by centering the Fan below the Ashlip and
align the Fan Support Clips with the Ofset Clips under the
Ashlip.
Note: The Draft Control Rod is to it through the top open-
ing in the Switch Plate.
Draft Control
Rod
Switch
Plate

FAN INSTALLATION

Left Side Fan
Facia
Right Side
Fan Facia
Ashlip
Fan
Support Clips
IMPORTANT
Ensure that the Left and Right Side Fan Facia do not
hit the sides of the Faceplate when sliding the Fan into
position as the casting may chip.
If the spacing between the Side Fan Facia and the Face-
plate requires adjustment, the Side Fan Facia's can be
slightly pushed in or pulled out to it accordingly.
3) Ensure the power cord and all other wires will not come into
contact with any hot stove surfaces.
DO NOT ROUTE POWER CORD UNDER
OR IN FRONT OF UNIT.
Do not turn the fan ON until your insert has reached operating
temperature or at least 30 minutes after starting ire.
Neutral
Green
Live
Ground
120V AC
60 Hz
Fan Thermodisc
(normally open)
Black
Black
Blower/Fan Wiring Diagram
installation
Manual/
Fan
Auto
Switch
Switch
Black
Fan Fan
Hampton HI300 Wood Cast Insert
|
19
Ground
| 19