Printer Requirements; Ink Requirements; Label Design Requirements; Print Requirements - Rimage Allegro 20 User Manual

Printer Requirements

This section describes the ink, label design, and print requirements for the
Rimage Allegro 20 system.

Ink Requirements

Important!
Use only authentic Rimage All-in-One Ink Cartridges in the Allegro 20.
•
• Keep All-in-One Ink Cartridges sealed in their original packaging until
they are needed.
Store cartridges at room temperature (60° to 78° F / 15.6° to 26.6° C).
•
Store All-in-One Ink Cartridges in an upright position, not on their sides or
•
upside down.
• Do not remove the protective tape from a new All-in-One Ink Cartridge
until immediately before installation. After you remove the tape, do not
reapply it.
• After you have removed the protective tape, do not touch the contacts
and nozzles.
Print discs at least once a month to keep All-in-One Ink Cartridges in
•
good working order.
The Rimage Allegro 20 will work only with an authentic Rimage All-in-One
Ink Cartridge.

Label Design Requirements

The Rimage Software Suite includes a label editor called CD Designer™,
which is installed on your PC during a typical installation of Rimage software.
You can use CD Designer to design your disc labels.
If you prefer to design labels in a software application other than CD
Designer, use the following criteria:
• File format: For best results, save your labels as JPEG or TIFF files. If
you use CD Designer to print labels, you must import the labels and save
them as CD Designer files (.btw) before printing.
2003750_B
•
•
•
Note:
of 4.65 in / 118 mm and an inside diameter of 0.95 in / 24 mm. On most
labels, print settings of 118 mm and 24 mm are recommended. Please refer
to the image.

Print Requirements

All labels created and saved through CD Designer are in the correct file
format (.btw) for printing with the Rimage Allegro 20. If you are creating
and saving labels with a software application other than CD Designer,
save your labels as PDF files before printing with the Rimage Allegro 20.
For more information visit rimage.com/support
Color mode: Labels imported into CD Designer must be in RGB color
mode.
Resolution (pixels per inch): For best results, use images set to a
minimum of 300 pixels per inch.
Label design size: Design labels with a height of 4.72 in / 120 mm and
a width of 4.72 in / 120 mm. This is the diameter of a full-size disc. The
hole is 0.59 in / 15 mm. The printable area and hub sizes may vary
between disc manufacturers.
Printable Area
4.65 in / 118 mm
0.95 in / 24 mm
Most Rimage media has a printable area with an outside diameter
Hub Size
7