Adjusting The Headlight Range; Changing The Speedometer Battery - Husqvarna FE 450 2016 Owner's Manual

15 ELECTRICAL SYSTEM
15.11

Adjusting the headlight range

15.12

Changing the speedometer battery

Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for
a motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
S00506-10
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
S00505-10
–
Using a coin, turn protection cap
–
Remove speedometer battery
–
Insert the new battery with the label facing outward.
Speedometer battery (CR 2032) (
–
Check the O-ring of the protection cap for correct seating.
B01644-10
–
Position protection cap
–
Press any button on the speedometer.
The speedometer is activated.
–
Position the speedometer in the holder.
–
Mount and tighten the screws with washers.
B01645-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Set the speedometer. (
p. 88)

.

.

.

all the way counterclockwise and remove it.

.
p. 110)

and turn all the way clockwise using a coin.
p. 88)
p. 21)
p. 85)
p. 86)
89