12
SERVICE WORK ON THE CHASSIS
–
Clean main silencer housing
–
Mount a new O-ring
–
Position silencer cap
Guideline
Screws on the main silencer
Finishing work
–
Install the main silencer. (
–
Install the right side cover. (
12.30
Installing the main silencer
12.31
Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
and screen
of the spark arrestor with compressed air.
on silencer cap
.
. Mount and tighten screws
p. 57)
p. 58)
Main work
–
Mount the main silencer. Mount screws
–
Reconnect spring
Spring hooks (50305017000)
–
Tighten screws
Guideline
Remaining screws, chassis
S00907-11
Finishing work
–
Install the right side cover. (
Preparatory work
–
Remove the right side cover. (
–
Remove the main silencer. (
Main work
(FE EU/AU)
–
Remove all screws on the main silencer.
–
Take off silencer cap
–
Take off outer tube
–
Remove glass fiber yarn filling
–
Clean the parts that need to be reinstalled and check for damage.
–
Mount the new glass fiber yarn filling on the inner tube.
–
Mount O-ring
–
Position the inner tube with the connecting cap and glass fiber yarn filling in
the outer tube.
–
Mount O-ring
–
Position the silencer cap with O-ring
–
Mount and tighten all of the screws.
Guideline
M00435-10
.
M5
.
.
p. 58)
p. 55)
and O-ring
and O-ring
onto connecting cap
on the silencer cap.
Screws on the main silencer
7 Nm (5.2 lbf ft)
but do not tighten yet.
M6
p. 58)
.
.
from inner tube
.
.
in the outer tube.
M5
57
10 Nm (7.4 lbf ft)
7 Nm (5.2 lbf ft)