15
ELECTRICAL SYSTEM
15.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at
least 15 minutes and contact a physician.
15.2
Installing the battery
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
the battery.
–
Pull back the positive terminal cover
the battery.
–
Detach rubber band
–
Lift the battery up and out.
H00232-10
Main work
–
Insert battery into the battery compartment with the terminals facing to the front.
Battery (YTX5L-BS) (
–
Reconnect rubber band
Info
Contact disk
socket
–
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal
–
Slide positive terminal cover
–
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal
H00233-10
–
Slide negative terminal cover
Finishing work
–
Mount the seat. (
p. 49)
and disconnect the positive cable from
at the bottom.
p. 110)
.
must be mounted between screw
with the claws facing down.
over the positive terminal.
over the negative terminal.
p. 50)
and disconnect the negative cable from
and cable
M5
2.5 Nm
(1.84 lbf ft)
M5
2.5 Nm
(1.84 lbf ft)
82