Husqvarna FE 450 2016 Owner's Manual page 78

13 BRAKE SYSTEM
–
Stand the vehicle upright.
–
Remove screw cap
B01793-10
–
Press the brake caliper onto the brake disc by hand in order to push back the
brake piston and ensure that brake fluid does not flow out of the brake fluid reser-
voir, extracting it by suction if it does.
Info
Ensure that the brake caliper is not pressed against the spokes when
pushing back the brake piston.
–
Remove cotter pin
–
Clean the brake caliper and brake caliper support.
M01230-10
–
Check that leaf spring
caliper support are seated properly.
The arrow on the leaf spring points in the rotation direction of the brake disc.
M01232-10
–
Insert the new brake linings, insert pin
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
brake lining.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
M01231-10
–
Add brake fluid to level
Brake fluid DOT 4 (
–
Mount screw cap
Info
Clean up overflowed or spilt brake fluid immediately with water.
B01794-10
 
with membrane and the O-ring.
 
, pull out pin and remove the brake linings.

in the brake caliper and sliding plate

, and mount cotter pins

is mounted on the piston side of the

.
p. 113)
 
with membrane and O-ring.
76

in the brake

.