Husqvarna FE 450 2016 Owner's Manual page 48

12 SERVICE WORK ON THE CHASSIS
–
Position the fork legs.
Bleeder screws
Info
The compression damping is located in the left fork leg COMP (white
adjusting screw). The rebound damping is located in the right fork leg REB
(red adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
402556-11
–
Tighten screws
Guideline
Screw, bottom triple clamp
H00180-10
–
Tighten screw
Guideline
Screw, top steering head
H00218-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
H00234-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
H00180-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
H00178-11
Finishing work
–
Install the front fender. (

are positioned toward the front.

.

.

.
M8

.
M8
p. 48)
M8 15 Nm (11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
17 Nm Loctite
(12.5 lbf ft)
M8 17 Nm (12.5 lbf ft)

.

.
25 Nm Loctite
(18.4 lbf ft)
46
® 243™
® 243™

.