Installing The Controller - LSI MegaRAID SAS 9265-8i Quick Installation Manual

Installing the Controller

Installing the Controller
Page 4
NOTE: Record your controller serial number in a safe location in case you need to
contact LSI.
NOTE: SATA II is the only type of SATA supported by this RAID controller.
Back up your data before changing your system configuration.
!
Otherwise, you might lose data.
CAUTION
1. Unpack the RAID Controller
Unpack the RAID controller in a static-free environment. Remove it from the
antistatic bag, and inspect it for damage. If the RAID controller appears to be
damaged, or if the MegaRAID Universal Software Suite CD is missing, contact LSI or
your MegaRAID OEM support representative.
The CD contains utility programs, device drivers for various operating systems, and
the following documentation:
— MegaRAID 6Gb/s SAS RAID Controllers User Guide
— MegaRAID SAS Software User Guide
— MegaRAID SAS Device Driver Installation User's Guide
— Cache Backup Products for MegaRAID SAS RAID Controllers User Guide
— MegaRAID LSIiBBU09 Intelligent Battery Backup Unit Quick Installation
Guide
— Software license agreement
2. Prepare the Computer
Turn off the computer, and unplug the power cords from the rear of the power
supply. Remove the cover from the computer.
Before you install the RAID controller, make sure that the computer is
!
disconnected from the power and from any networks.
CAUTION
3. Review the Jumpers and the Connectors
Figure 2 shows the location of the jumpers and the connectors on the RAID
controller. The jumpers are set at the factory, and you usually do not need to change
them.
MegaRAID SAS 9265-8i RAID Controller Quick Installation Guide
LSI Corporation
|
December 2010