Table of Contents
Advertisement
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
June 2012
2
Installing the RAID Controller
CAUTION Back up your data before changing your system configuration. Otherwise, you might lose data.
1. Unpack the RAID controller.
Unpack the RAID controller in a static-free environment. Remove it from the antistatic bag, and inspect it for
damage. If the RAID controller appears to be damaged, or if the MegaRAID Universal Software Suite CD is missing,
contact LSI or your MegaRAID OEM support representative.
The CD contains utility programs, device drivers for various operating systems, and the following documentation:
6Gb/s MegaRAID SAS RAID Controllers User Guide
—
MegaRAID SAS Software User Guide
—
MegaRAID SAS Device Driver Installation User's Guide
—
Cache Backup Products for MegaRAID SAS+SATA RAID Controllers User Guide
—
Software license agreement
—
2.
Prepare the computer.
Turn off the computer, and unplug the power cords from the rear of the power supply. Remove the cover from
the computer.
3. Review the jumpers and the connectors.
The following figure shows the location of the jumpers and the connectors on the RAID controller. The jumpers
are set at the factory, and you usually do not need to change them.
Figure 2 Layout of the MegaRAID SAS 9286CV-8eCC RAID Controller
J1A1 J1A3
J1A4
J1B1
CAUTION Before you install the RAID controller, make sure that the computer is disconnected from the
power and from any networks.
J2A1 J2A2
J2A4
J2B1
J4A1
J4A2
J5A1
J5B1
LSI Corporation
- 5 -
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
J6A1
3_00922-00
Advertisement
Table of Contents
