LSI MegaRAID SAS 9265-8i Quick Installation Manual page 6

Installing the Controller
Page 6
Table 1: Jumpers and Connectors (Continued)
Jumper/
Connector
J1A5 Individual PHY and Drive Fault
Indication header
Ports 3-0
Ports 7-4
- v e
+ve
k a
J1A5
J1A7 2
I C Enclosure Management
connector
1
2
3
J1A7
J1B1 Serial EEPROM (SBR)
J2B1 x4 SAS Ports 0-3 internal connector
J2B2 x4 SAS Ports 4-7 internal connector
J2B3 Advanced Software Hardware Key
header
MegaRAID SAS 9265-8i RAID Controller Quick Installation Guide
Type
2x8-pin header
Connects to an LED that indicates whether
a drive is in a fault condition. There is one
LED per port. When lit, each LED indicates
the corresponding drive has failed or is in
the Unconfigured-Bad state.
The LEDs function in a direct-attach
configuration (there are no SAS
expanders). Direct attach is defined as a
maximum of one drive connected directly
to each port.
3-pin connector
Supports SES (SCSI enclosure services)
2
over I
cable.
2-pin connector
Provides controller information, such as
the serial number, revision, and
manufacturing date. The default is no
shunt installed.
SFF-8087 mini SAS 4i internal connector
Connects the controller by cable to SAS
drives or SATA 2 drives.
SFF-8087 mini SAS 4i internal connector
Connects the controller by cable to SAS
drives or SATA 2 drives.
3-pin header
Enables support for selected advanced
features, such as recovery, CacheCade,
FastPath, and SafeStore disk encryption.
Description
2
C through an internal I C backplane
|
LSI Corporation December 2010