Remote Control Button Programming - Paradox MG-RCV3 Reference & Installation Manual

The User Code assigned to the remote control (refer to section 8.2 on
page 25) must have the same options enabled as the remote control.
For example, if you enable the Force Arming button option, you must
enable the appropriate Force Arming user option in the control panel.
Also, if you enable any Panic button options, you must enable the
Panic options in the control panel (refer to the appropriate Reference &
Installation Manual).
In Spectra systems, to verify the remote control button programming
using LED keypads, enter the desired section, press the [
enter display mode and then press [
LED hexadecimal indicators (refer to Table 8.5 on page 32) will
illuminate one at a time as you press the [
Digiplex
Spectra
RC#
Section
Section
1 [711]
2 [712]
3 [713]
4 [714]
5 [715]
6 [716]
7 [717]
= These button combinations are not available with the
MG-REM1 remote control and cannot be programmed.
28
Table 8.3: Remote Control Button Programming
Series
_____/_____/_____/_____/_____/_____/_____/_____
[401]
_____/_____/_____/_____/_____/_____/_____/_____
[402]
_____/_____/_____/_____/_____/_____/_____/_____
[403]
_____/_____/_____/_____/_____/_____/_____/_____
[404]
_____/_____/_____/_____/_____/_____/_____/_____
[405]
_____/_____/_____/_____/_____/_____/_____/_____
[406]
_____/_____/_____/_____/_____/_____/_____/_____
[407]
] once for every value. The
ENTER
ENTER
RC Buttons
(refer to Table 8.4 on page 30)
Default: ( 1 5 0 0 0 0 0 0 )
Reference & Installation Manual
ENTER
] key.
+
+ +
+
+ +
+
+ +
+
+ +
+
+ +
+
+ +
+
+ +
] key to
+
+
+
+
+
+
+