Programmable Outputs; Pgm Connection; Pgm Activation; Pgm Deactivation - Paradox MG-RCV3 Reference & Installation Manual

7.0 Programmable Outputs (PGMs)
The MG-RCV3 comes equipped with four on-board PGM outputs. However, only
PGMs 3 and 4 are used when connected to a Spectra or Digiplex series control
panel.
• PGM 1 and 2: Not used
• PGM 3: Form "C" relay output rated at 5A/28Vdc, N.O./N.C
• PGM 4: Optional form "C" relay output rated at 5A/28Vdc, N.O./N.C

7.1 PGM Connection

The PGMs are connected as detailed in Figure 2.2 on page 6.

7.2 PGM Activation

PGM 3 and PGM 4 are always enabled and are activated only through the
Magellan remote control. Remote control button
30) controls PGM 3, and button
remote control button to activate the corresponding PGM. If the PGM
deactivation mode is set to "Manually" (refer to section 7.3), the button used to
activate the PGM will also be used to deactivate the PGM.
If remote control button
action (refer to section 8.3 on page 26), pressing the button will
activate the PGM and perform the programmed action as well. For
example, if button
pressing button

7.3 PGM Deactivation

S :
PECTRA SECTION
D
IGIPLEX SERIES
Once a PGM has been activated (refer to section 7.2 on page 20), options [6]
and [7] determine how the PGM will deactivate. If the option is OFF, the
activated PGM will automatically deactivate after two seconds. If the option is
20
is programmed to Regular arm the system,
will activate PGM 3 and Regular arm the system.
[610]:
OPTIONS
: [001]:
SECTION OPTIONS
(refer to Figure 8.2 on page
controls PGM 4. Press the appropriate
or is programmed to perform another
[6] [7]
AND
[6] [7]
AND
Reference & Installation Manual