Spectra Programming; Digiplex Series Programming; Transmitter Programming; Interrelated Spectra Transmitter (Tx) Sections - Paradox MG-RCV3 Reference & Installation Manual

3.1 Spectra Programming

The module is programmed within the control panel's programming from any
keypad connected to the system.
How to program:
1. Press the [
2. Enter your [
3. Enter the [
4. Enter the required [

3.2 Digiplex Series Programming

The MG-RCV3's programming is done through the control panel's Module
Programming Mode from any keypad connected to the system. Programming
can also be done through the WinLoad software.
How to program:
1. Press and hold the [0] button.
2. Enter your [
3. Enter section [953] (DGP-848) or [4003] (DGP-NE96).
4. Enter Magellan's 8-digit [
5. Enter the [
6. Enter the required [

4.0 Transmitter Programming

For Spectra systems, up to eight transmitters can be assigned to each MG-RCV3.
Digiplex series systems support up to 16 transmitters. The following tables display
the interrelated transmitter sections:
Table 4.1: Interrelated Spectra Transmitter (Tx) Sections
Expansion Input #
8
] button.
ENTER
INSTALLER CODE
] you wish to program.
SECTION NUMBER
].
DATA
INSTALLER CODE
SERIAL NUMBER
] you wish to program.
SECTION NUMBER
].
DATA
Assign Tx to
1
8
] (default = 000000).
] (default = 000000).
].
module
[601]
[608]
Reference & Installation Manual
View Tx Signal
Strength
[631]
[638]