Appendix A: Installing The Lap-Teq Inclinometer On Kibu-Sb - L-Acoustics KIBUII Rigging Manual

APPENDIX A: Installing the LAP-TEQ inclinometer on KIBU-SB

Tools
— torque screwdriver
— T20 Torx bit
— 7 mm wrench
About this task
KIBU-SB is equipped with a support plate for installing the TEQSAS LAP-TEQ inclinometer provided in the TECH
TOOLCASE.
slit opening
support plate for laser
Calibrating the LAP-TEQ
Refer to the manufacturer instructions in the L-Acoustics TECH TOOLCASE.
An additional XLR3 cable is needed.
Exploded view
Use the screws and nuts provided with the KIBU-SB.
Before tightening the screws, align the laser with the slit opening.
3 N.m
49
T20
APPENDIX A: Installing the LAP-TEQ inclinometer on KIBU-SB
7 mm
Kiva II rigging manual (EN) version 2.0