Appendix B: Installing The Lap-Teq Inclinometer On A15-Bump - L-Acoustics A15 Series Owner's Manual

Installing an inclinometer on A15-BUMP
Installing an inclinometer on A15-BUMP
Tools
• torque screwdriver
• T20 Torx bit
• 7 mm wrench
About this task
A15-BUMP is equipped with a support plate for installing an optional inclinometer. Three models are compatible:
® LAP-TEQ PLUS (provided in the TECH TOOLCASE), TEQSAS
TEQSAS
Compact.
LAP-TEQ / LAP-TEQ PLUS sensor and display compatibility
The legacy LAP-TEQ sensors are compatible with the new TEQSAS
Conversely, the new sensors are not compatible with the legacy displays.
With two sets of xation points and eight slit openings, the position and orientation of the laser support plate can be
adapted to every use of the rigging frame.
fixation points (rear)
slit openings (rear)
support plate
Calibrating the inclinometer
Refer to the manufacturer instructions.
An additional XLR cable is needed.
Exploded view
Use the screws and nuts provided with A15-BUMP.
Before tightening the screws, align the laser with the slit opening.
96
®
fixation points (front)
slit openings (front)
T25
7 mm
LAP-TEQ (legacy model), and KSG
®
LAP-TEQ PLUS displays.
3 N.m
A15 owner's manual (EN) version 1.2
®
RECLINE