Table of Contents
Advertisement
13
Settings at the Submenu-Parameter
After entering the SUBMENU PARAMETER, the display
... will change to
Set Password 0066 by pressing
Confirm by pressing
parameter of the sub menu is shown
13.1 Pressure change
Change Pressure
Enabled
If the pressure setting is enabled, you can change the required pressure on the
Hydrovarhead with decrease and increase (see chapter 7) without an external
programming device.
Press
on the controller to change to
13.2 Auto start
Auto Start
Enabled
Autostart Enabled means, that the pump starts again automatically after an
interruption of the power supply (power failure).
If Autostart Disabled is set, the pump has to be restarted manually after a power
failure, by pressing
Press
on the controller to change to
Important: Before entering the secondary menu these instructions
must be read carefully to prevent incorrect settings which will
cause malfunction.
Note: The password must be entered at each entry
and the first
You can decide between
(
You can select between
and
.
and
Disabled)
41
PASSWORD
0000
PASSWORD
0066
Change Pressure
Enabled
(Enabled) or
Disabled and
Enabled
Hide quick links:
Advertisement
Table of Contents
