Table of Contents
Advertisement
Example:
To change the Hydrovar with address 01 to address 04:
press the
button to change the * to the left side
Select the address of the Hydrovar, you want to change the
address with the
press the
button to change the * to the right side
Select the address you want to give this Hydrovar with the
and
button
To confirm and save the new selected address press both buttons (
for 2 sec. If it was successfully you will see the same address on both sides.
The definition of the address you have to do for each pump in the system.
Hold the
button down for 3 seconds to return to:
Hold the
button down again for 3 seconds to return to
the 1
st
display
12
Settings at the Invertermenu
1
st
display
PRESS
SPEED X.X Hz
Press
on the controller to change to
PRESSURE
Press
on the controller to change to
SUBMENU
PARAMETER
Press
on the controller to change to 1
and
button
X.X bar
XX.X bar
The actual input value [bar] and the actual
output frequency [Hz] are displayed.
There you can set required pressure
with the buttons
To enter the submenu "Parameter",
press
button
st
display
40
Address Change
00* --> 00
Address Change
01* --> 00
Address Change
01 --> 00*
Address Change
01 --> 04*
and
) together
Address Change
04 --> 04*
SUBMENU
Address
PRESSURE x.x bar
SPEED xx Hz
and
Hide quick links:
Advertisement
Table of Contents
