Table of Contents
Advertisement
pump has reached the programmed release-frequency. (Adjustable from 0.0 Hz to
70 Hz). If you don't want to start a following pump this value has to be set higher
than the MAX. FREQUENCY (see chapter 13.5.1)
Press
on the controller to change to
13.7.4 Switch Interval
Switch Interval
24 hours
To leave the submenu press the
13.8 Submenu Relay
Submenu
13.8.1 Relay Configuration
Relay Configu.
Simple Multicnt.
Attn:
Max. contact load 500mA / 125V
Press
on the controller to change to
13.8.2 Start frequency of the slave pump
Slave-On Limit
50,0 Hz
slave pump should start, if "simple multicontroller" is set in the parameter Relay
configuration (see capter 13.8.1). In this case, the slave pump runs with full speed and
the HYDROVAR-pump controls the additional demand.
Press
on the controller to change to
13.8.3 Stop frequency of the slave pump
Slave-Off Limit
For changing the master pump and follow-up
pump in order to achieve even operating hours of
the pumps. Adjustable between 0 and 250 hours
To enter this menu you have to press the
Relay
leave the menu, press the
Possible selections with buttons
Simple Multicnt. ⇒ allows to start a following
(simple multi-
Run Signalling
Error Signalling
Here you can set the frequency of the speed
controlled HYDROVAR-pump, when the full speed
Here you can set the frequency of the speed
key longer than 3 sec.!
controller)
49
key longer than 3 sec.
and
constant speed pump.
(see chapter 13.8.2 / 13.8.3.)
⇒ Run indication over the relay
⇒ fault indication over the relay
key, to
:
Hide quick links:
Advertisement
Table of Contents
