Table of Contents
Advertisement
30.0 Hz
slave pump should stop, if "simple multicontroller" is set in the parameter Relay
configuration (see capter 13.8.1).
To leave the submenu press the
13.9 Submenu Sensor
Submenu
Sensor
13.9.1 Sensor – Adjust
SENSOR_ADJUST ?
Out of range
simultaneously. After adjustment "adjusted" appears on the display. If "out of range" is
shown on the display, no adjustment is possible (e.g. when pressure is in the
system....)
Press
on the controller to change to
13.9.2 SensorMax-Adjust
SENSORMAX-ADJUST
0,5 – 4,5 V
When there is used a transmitter with another signal range, you can also choose an
input signal of 0,5 – 2,5VDC ( for example a 4-20mA-transmitter with an external load
resistor of 125 ohm/0,25W) with the buttons
To leave the submenu press the
13.10 Submenu Test-Run
Submenu
Testrun
13.10.1 Start of manual test run
Start Test Run
After starting this test run, the pump will speed up with the fasten ramp 1 to the in the
parameter 13.10.3 setted speed and then will ramp down with the fasten ramp 2.
controlled HYDROVAR-pump, where the full speed
key longer than 3 sec.!
To enter this menu you have to press the
leave the menu, press the
Zero adjustment of the transmitter
Depressurise the system and press keys
The analogue input (terminal X2/2) is prepared for a
transmitter signal of 0,5 – 4,5VDC.
key longer than 3 sec.!
To enter this menu you have to press the
leave the menu, press the
By simultaneously pressing
+
released even if the test cycle is not set.
+
.
50
key, to
key longer than 3 sec.
+
key, to
key longer than 3 sec.
+
a test run will be
Hide quick links:
Advertisement
Table of Contents
