Table of Contents
Advertisement
General for working with the external programming device:
With
and
To enter a submenu, press the
the buttons
With
or
Each change in the settings is saved after leaving this parameter with the buttons
or
.
When you have changed a parameter and you leave it, the LCD shows you the
following message
PARAMETER
10
Connecting the external programming device to the HYDROVAR
After connection of the HYDROVAR – head to the power supply and plug in of the
external programming device, there can be shown two different messages:
1. If the AUTOCONNECTION (14.1.1) is disabled (standard) you reach:
Address
At this time the Hydrovar searches for an available address
If address 01 is available, the display changes to
Address
Detected
Statusinformations by systems with activated Multicontroller:
P1: Masterpump
P2: Slavepump
P3: Slavepump
P4: Slavepump
P.: Follownumber is not useful
Hold:
pump stops through the pressure transmitter
Run:
pump runs
Stop:
pump stops through the leadpump
Disabled: pump stops through the stopbutton or the terminal block
Error:
pump stops through an error
Follow pump stopped
Regulator from the follow pump is release
Pump don't work at the follow pump
you can select the different parameters in the menu.
or
for longer than 3 sec.
you can change the parameters.
SAVE
for about 2 sec.
01
This message is shown, when the Remote Control is
Lost
new connected
01
The actual pump-address is shown
button. To leave the submenu, you have to press
28
Hide quick links:
Advertisement
Table of Contents
