Heinner HWM-M7012HA+++ Manual page 17

www.heinner.com
Cancel the Delay function: Press the Delay button until the display will be 0H.It should be pressed
before starting the program. If the program already started, should press the On/Off button.
Notes: If there is any break in the power supply while the machine is operating, a special memory
stores the selected programme and when the power is restarted, press the Start/Pause button the
left time is continues.
- Reload
This operation can be executed during the washing procedure. When the drum of the washing
machine is still rolling and there is large amount of water with high temperature in the drum. The
state is unsafe and the door cannot be opened forcefully. To press 《Start/Pause》for 3 sec. to
reload, and start the clothes adding in the midway function .
Please follow the steps as bellow:
1.Wait until the drum stops rotation.
2.The door lock is unlocked.
3.Close the door when the clothes needs are loaded and repress the《Start/Pause》button.
- Child Lock
To avoid that the washing procedure cannot operate normally due to the mis operation by kids
during the washing procedure, you can select this function, In this case, the other buttons except
On/Off button can not work, at this state ,the machine power off when press the key on/off. The
machine remembers the program child lock and the program during powered off when press the
key on/off again.
Press Extra Rinse and Pre Wash together 3 seconds during the running procedure, the buzzer will
beep ,Start/Pause button as well as the rotary switch are locked. Press the two buttons for 3
seconds together and buzzer will beep to release to locking. But cut off the power supply , the
kid's protection is also release to locking. The kid's protection will not be cancelled after all
procedures are completed.
- Suppression of the acoustic signals
This is an additional buzzer function on your appliance. After deactivating the buzzer function, the
buzzer will be closed.
After starting the machine, press the "Temp.&Spin" button for 3 seconds and you will hear a beep,
then the buzzer will be closed. To restart the buzzer function, press the "Temp.&Spin" button
again for 3 seconds. The setting will be kept until the next reset.
Warning: After deactivating the buzzer function, the sounds will not be activated any more.
- Bubble Removal Function
Bubble Check Function: Redundant bubbles will occur when there is excessive detergent, which
will affect wash and rinse effects. The procedure will check automatically and one bubble removal
procedure will be added automatically to remove bubbles when excessive bubbles are checked.
16