Teo 4104 Installation Instructions Manual page 34

Teo IP Phone 4104 Installation Instructions
A u t o A n s w e r
A u t o A n s w e r
A line appearance or group can be configured to automatically answer a call when the
phone is idle, if the call's SIP alert-info header matches a predefined string (up to 10 strings
can be defined; refer to the IP Telephone Network Administration Guide). Calls can be
answered in 2-way speakerphone mode, or with the microphone muted. Applications for
the Auto Answer feature include paging, intercom calls, ACD calls, and dialing or
answering from computer-based applications.
An Auto Answer enable/disable softkey is available for the user if Auto Answer has been
enabled for any line appearance. When disabled, auto answer calls will ring normally with
a distinctive ring pattern.
Select AA. The current Auto Answer state is shown in the top line of the
display.
Select ENABLE to enable Auto Answer for this line or group.
To change to Mute or 2-Way mode, press the rightmost softkey.
Select DISABLE to disable Auto Answer.
L a b e l ( L i n e A p p e a r a n c
L a b e l ( L i n e A p p e a r a n c
Note: The label entry for Line Appearance Key 1 is shown in large text when the phone
is idle. Label entries for any other line appearance keys are not used.
To customize the idle screen display, select LABEL.
The line ID is shown by default. To change the label, select CLEAR to remove
the existing label, or press the Left or Right Arrow key to move the cursor
position for editing. DELETE removes the character under the cursor.
Using the dial pad, enter a label, 18 characters max. (page 14). Fewer than 18
characters may be shown on the idle display, depending on character width.
Press the OK key to return to key selection.
Page 34
AUTO ANSWER=DISABLE
ENABLE
AUTO ANSWER=ENABLE/2WAY
DISABLE
AUTO ANSWER=ENABLE/MUTE
DISABLE
e K e y 1 o n l y )
e K e y 1 o n l y )
LBL=4321
DELETE CLEAR ABC
MUTE
2WAY
13-280131 Rev. J