senseFly EBEE RTK Extended User Manual page 133

– Pitch: The pitch angle with respect to vertical of the photo target.
– Altitude reference: The altitude reference of the photo target alti-
tude, either ATO or AMSL.
– Target altitude: The altitude of the photo target.
– Position (Coordinate): The precise latitude and longitude of the cen-
tre of the waypoint.
• New photo target increment: This panel makes it easier to make a se-
ries of oblique photos of the same target with a regular angle increment in
order to aid reconstruction of a 3D model. Every new Photo target that is
added using the
ous one, but with an increment in heading and pitch angles defined by the
'Heading increment' and 'Pitch increment' parameters, respectively.
Default value: Heading increment: 0
• Automatically reset target altitude based on elevation data: Check
this box to use elevation data to set the absolute photo target altitudes.
If this box is unchecked, photo targets are presumed to be at the same al-
titude as the take-off location.
Default value: disabled
The 'Camera control' section has the following functions:
• Take photo now: Clicking this button will send a command to the drone
to take a single picture at its current location. This command can be sent
during the mission phase of a flight plan.
Note: The 'Take photo now' button has no effect during Take-off, Cir-
cular landing, Linear landing and Emergency landing modes.
• Continuous photo sequence: These radio buttons define how the drone
is taking images. When the default option 'Auto' is selected the drone will
start and stop continuous photo shooting based on the actions associated
button will be placed at the same location as the previ-
eMotion in-depth guide
◦
, Pitch increment: 0
◦
133