Ethernet Commands - D-Link DAP-2695 Command Line Interface Reference Manual

Get Command:
get ipaddr
get ipmask
get gateway
get ipmode
get eth-updownlink
get updownlink
get uplink_bandwidth
get downlink_bandwidth
get nameaddr
get ipv6
Set Command:
set ipaddr
set ipmask
set gateway
set ipmode
set eth-updownlink
set fixedrate
802.11 b/g /n Access Point Command Line Interface Manual
Function
Display IP Address
Display IP Network/Subnet Mask
Display Gateway IP Address
Display IP Mode
Display ethernet uplink/downlink state
Display primary ssid uplink/downlink state
Display uplink bandwidth
Display downuplink bandwidth
Display DNS Address
Display IPv6 settings
Function
Set IP Address
Set IP Network/Subnet Mask
Set Gateway IP Address
Set IP Mode(Static or Dynamic)
Set ethernet uplink/downlink state
Set Fixed Rate
get ipaddr
get ipmask
get gateway
get ipmode
get eth-updownlink
get updownlink
get uplink_bandwidth
get downlink_bandwidth
get nameaddr
get ipv6
set ipaddr <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ipmask < xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is Network
mask
set gateway <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ipmode
set eth-updownlink [link/down/none]
set fixedrate
10

ETHERNET COMMANDS

Syntax
Syntax
4