Table of Contents
Advertisement
___________
Specifications
Product Number
Model Number
FCC ID
IC ID
Connectors
Antenna Impedance
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Noise Figure
Isolation
Power Requirements
The term "IC" before the radio certification number only signifies that Industry Canada technical specifications were met.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter
incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency
band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that
band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster
has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster's microprocessor.
14
IN-BUILDING SIGNAL BOOSTER WITH IN-LINE AMPLIFICATION
698-716 MHz, 729-746 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700
Band12/17
700
MHz
MHz
24.7
24.7
700
Band12/17
700
MHz
MHz
14.8
14.3
1050 Main
5 dB nominal
> 90 dB
110-220V AC
460030
460030
PWO460030 / PWO0460030IL
4726A-460030
N-F emale
50 Ohms
Band13
800
MHz
24.3
Band13
800
MHz
15.2
1700
1900
MHz
MHz
25.1
24.5
2100
1900
MHz
MHz
15
15.1
1050 In-Line
5 dB nominal
> 90 dB
5V 3A
WILSON PRO 1050
Advertisement
Table of Contents
