Advertisement
Set Up and Operation
The Concert Series is a 3-way active system.
You can make several combinations, by using the different components.
• D3470 - 1 active coaxial top unit with 12" woofer and 3" tweeter 1000 Watt / 8 Ohm, equipped with
amplifier and all the electronics required to run the system.
• D3471 - 1 active subwoofer 18" 1200 watt / 6 Ohm, equipped with amplifier and all the electronics
required to run the system.
• D3472 - 1 active subwoofer 18" 1000 watt / 6 Ohm, equipped with amplifier and all the electronics
required to run the system.
Each subwoofer or the top cabinet has its own built-in amplifier.
Further built-in are the crossovers, frequency response correction circuits, breaker circuitry.
The Concert Series can be used for large live gigs, events and concerts.
It's easy to set up; All you have to do is set up the system components, connect the signal-carrying cables
and power cords and you're ready to roll.
Signal Input
This combined XLR 6,3mm jack socket serve as input for the audio signal. There is also 1 parallel output for
connecting an active loudspeaker system or an additional power amp.
Mains Switch
Do not supply power before the whole system is set up and connected properly.
Connection Cables
Take care of the connector cables, always holding them by the connectors and avoiding knots and twists
when coiling them: This gives the advantage of increasing their life and reliability, which is always to your
advantage.
Periodically check that your cables are in good condition, that they are correctly wired and that all their
contacts are perfectly efficient: a great number of problems (faulty contacts, ground hum, discharges, etc.)
are caused entirely by using unsuitable or faulty cables.
Headphones
Unbalanced mono 1/4" jack plug
Balanced mono 1/4" jack plug
7
Advertisement
