Software Installation And Setup - Videx 25H/SP/DDA/2W Technical Manual

25H/SP/DDA/2W

SOFTWARE INSTALLATION AND SETUP

SOFTWARE INSTALLATION AND SETUP
Before connecting the UIM-138 module to a PC or laptop please ensure that the USB driver has been installed
from the software CD (refer to the quick USB driver setup guide on page 35).
After the USB driver has been installed ensure that the UIM-138 is connected to the 138N speaker amp using
the 'plug-in' wire harness and any necessary auxiliary inputs/outputs are connected (this will depend on the
users requirements). Ensure that the latest VX2X00 version of software is installed on the PC or laptop (version
7.0.0.7 or later, refer to the quick software setup guide on page 35) and there is 12Vdc power connected into the
138N amplifier. After the software is installed connect the UIM-138 display module to the PC or laptop using
the USB cable provided, as shown in Fig.1 below.
PC
PORT
Launching the Software
Launch the 2X00PC software by
double clicking on the desktop icon.
25H/SP/DDA/2W - TECHNICAL MANUAL
(1 way "2 wire" DDA audio intercom kit)
USB
UIM-138 WIRING
HARNESS CONNECTED
TO 138N AMPLIFIER
USB CABLE
The initial launch window will appear (as shown to the right). At
the top of the window the software will show that it is checking
for any devices connected to the PC or laptop.
15
VIDEX
DISPLAY MODULE
OPTIONAL AUXILIARY
INPUT/OUTPUT
CONNECTIONS
Fig.1
EN-UK - V.1.2 - 04/01/16