Advertisement
Connect internal devices and set jumpers
This section gives the procedure for connecting internal devices to the CR100 carrier board, such
as disk drives and LAN cards, and configuring jumper settings.
1. Connect the following internal devices to connectors on the carrier board as needed. The
installation order is not important. For further information about attaching devices, refer to
the Procelerant CR100 FlexATX Carrier Board Product Manual.
CR100 connector
Internal USB headers
PCI Express x1 slot
IDE header
SATA connectors
LVDS flat panel connector
Backlight control connector One backlight control connector for the LVDS
2. If you have a CR100‐2DVI carrier board, you may need to specify which DVI‐I connector will
output VGA signals with the 2‐pin DVI output selection header. For instructions on
connecting a DVI digital video monitor or analog VGA monitor, see Connect external I/O
devices and chassis components on page 20.
• Pins 1 and 2 jumpered (default)—Obtains analog VGA output from the secondary DVI‐I
port J2
• Pins 1 and 2 open—Obtains VGA output from the primary DVI‐I port J1
3. If you have a CR100‐PCIE16 carrier board, insert a PCI Express graphics card into the PCI
Express x16 graphics slot.
4. The 2‐pin boot BIOS selection header specifies whether the system will use the BIOS on the
carrier board or the BIOS on the module when booting:
• Pins 1 and 2 open (default)—The system will boot from the COM Express module BIOS,
which is based on the Phoenix
• Pins 1 and 2 jumpered—The system will boot from the carrier board BIOS.
Note: Refer to Procelerant CR100 FlexATX Carrier Board Product Manual if you plan to install
a BIOS chip on the CR100 carrier board.
5. Connect the power supply to the 24‐pin ATX PSU connector on the CR100 carrier board. The
power supply connector must be a 24‐pin or 20‐pin
Specification Version 2.2.
1
If a 20-pin cable is used, plug the 20-pin cable in to the pin #1 end of the connector, and leave the two pairs of pins on the other
end exposed. No adaptor is required. Pin #1 is marked by an asterisk (*) on the CR100 carrier board.
Device to connect
Up to two internal USB devices
PCI Express x1 device, such as a LAN card
One IDE device, such as a CD-ROM drive or
hard disk drive
Up to two SATA devices, such as hard disk
drives
One LVDS flat panel
flat panel
FirstBIOS™ Notebook (Pro) BIOS with RadiSys extensions.
®
Cable type
Standard 5-pin USB cable
N/A
Standard IDE cable, complies with the
ATAPI industrial specification
Standard SATA cable, compliant with SATA
specification 1.0
Standard 30-pin LVDS cable
Custom; attaches to 7-pin 1.25mm header
1
connector that complies with ATX
19
Advertisement
