Download Print this page

RadiSys CE915GM Quick Start Manual page 21

Com express module
Hide thumbs Also See for CE915GM:

Advertisement

4. Connect the following devices to external ports on the rear I/O panel as needed. The 
installation order is not important. For additional information, refer to the Product Manual 
and the Procelerant CR100 FlexATX Carrier Board Product Manual.
CR100 connector
S-Video output port (located on
front of CR100 carrier board)
Ethernet port
Audio jacks
Note: The CR100 carrier does not provide an onboard PC speaker. It is recommended that 
you connect an external speaker to the fron panel I/O header in order to hear diagnostic 
sounds during system boot.
Power on the system
1. If an LVDS flat panel is attached and requires an external power supply, power it up before 
powering up the system. Otherwise, the panel's power supply will be provided by the CR100 
carrier board via the backlight control connector.
2. Plug in the power supply. The system should automatically power on the first time the power 
supply is connected, but you may have to press the power button on the chassis (if 
connected) or the power button on the CR100 carrier board.
Check the BIOS settings
It is a good idea to check the BIOS settings before installing the operating system to make sure 
the default settings are appropriate for devices you have installed. To enter the BIOS Setup utility, 
press F2 during system boot. 
After installing the operating system, you may also want to change the boot order in the BIOS, so 
that the hard disk is checked first.
If problems are encountered during boot up, error messages may be displayed on the monitor. 
You can also use a POST card to determine where the system encountered problems.
Online help is provided in the BIOS setup to explain options. For further information, refer to the 
Product Manual.
Device to connect
TV or other S-Video–compatible device
LAN, router, or other Ethernet device
Microphone and speaker
Cable type
Standard MiniDin4 male S-Video cable
For 10/100Base-T connections, a Cat5 cable
is required; for 1000Base-T, a Cat5E cable is
required.
Standard audio cables with 3.5mm male
connectors
21

Advertisement

loading