Table of Contents
Advertisement
6-2 Instruction: configure engine by scanning configuration barcodes
Refer to the next page, the steps of configuration are:
a) Scan the SETUP barcode on the parameter setting part.
b) Enter the option mode by scanning the Parameter name barcode.
c) To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
alphanumeric entries (see section 6-32) individually as Para. value.
d) Scan the END barcode, listed on the bottom of each parameter setting part.
e) Notes that only one parameter can be setup at each time.
f)
Throughout the configuration barcode menus, the factory default settings are indicated with asterisks
(*).
Example: to set Flow control to be None.
Steps: Scan the following barcodes in order.
SETUP barcode
Parameter name
Para. option
Flow control
None
ACK/NAK
Inter-character delay
00-99 (1ms)
Reserved
Response delay
00-99 (100 ms)
Parameter name
barcode
Para. value
00
01*
00-99
00*
00-99
20*
Alphanumeric entries
END barcode
Figure 6-1 Set Flow control to be None
21
Advertisement
Table of Contents
