Toyota 2015 Hilux Owner's Manual page 302

302
4-5. Using the driving support systems
Vehicles with DPF system switch
● If the DPF system warning message "DPF FULL MANUAL
REGENERATION REQUIRED SEE OWNER'S MANUAL"/"DPF full
Manual regeneration required See owner's manual" appears on the
display, follow the procedure below to regenerate.
Stop the vehicle in a safe place.
1
Shift the shift lever to P (automatic transmission) or N (manual
2
transmission), and firmly set the parking brake.
Do not stop the engine.
Also, make sure that there are no flammable materials near the exhaust
pipe. (→P. 303)
Check the engine is warmed up. If the engine is cold, warm up the engine
by depressing the accelerator pedal.
Press the DPF system switch.
3
The DPF system warning message
shown in the illustration appears
on the display, and the idling
engine speed will increase.
Regeneration will take around 30 - 40 minutes to complete.
When the DPF system warning message goes out, the idling engine
speed will have finished returning to normal.
The DPF system switch may not operate when the vehicle is higher
than 4000 m (13123 ft.) above sea level.
*
1
: Depending on the situation, it may be necessary to depress the accelera-
tor pedal until the engine speed is increased to 3000 rpm. If the engine
coolant temperature or exhaust gas temperature is low, it may take a long
time to regenerate, or regeneration may be impossible.
*
2
: Time required for regeneration differs in accordance with the outside tem-
perature. Also, if the engine speed is still approximately 2000 rpm 10 min-
utes after pressing the DPF system switch, the exhaust gas temperature
may be low. In this case, depress the accelerator pedal to run the engine
at approximately 3000 rpm for a while.
*
1
* 2