■
Replacing battery
→P. 526
■
Displaying the Stop & Start system status
Operation status of the Stop & Start system can be displayed on the
(Drive information) screen of multi-information display. (→P. 123)
Smart Stop
After Start
After Reset
The display of "After Reset" can be reset.
●
To reset the display, press
to select "Reset", and then press and hold
●
To stop the reset procedure, press
■
Multi-information display messages
When the engine cannot be stopped by the Stop & Start system, and when
the engine automatically restarts while stopped by the Stop & Start system,
the following messages are displayed on the multi-information display.
●
When the engine cannot be stopped by the Stop & Start system
Message
"Depress
firmly to activate"
"For climate con-
trol"
4-5. Using the driving support systems
Displays the current engine stop time. Also, the
engine stop time when the air conditioning sys-
tem is on can be adjusted using the meter con-
trol switches. (→P. 284)
Displays the cumulative time that the engine is
stopped by the Stop & Start system from when
the engine is started until the engine is stopped.
Displays the cumulative time that the engine is
stopped by the Stop & Start system from the
previous reset until the system is reset again.
of the meter control switches, press "<" or ">"
.
The brake pedal is not depressed enough.
→ Operates when the brake pedal is
brake
depressed further after stopping the
vehicle.
Vehicles with automatic air conditioning sys-
tem:
• The air conditioning system is being used
when the ambient temperature is high or
low.
→ Readily operates when the difference
between the set temperature and cabin
temperature is small.
•
is pressed.
.
Details/Actions
285
4